Tyres Oatley - 4 Mistakes you should Avoid

It may sound easy and simple to keep your tyres functional but there is a lot more struggle to do so. There must be accurate tyre and wheel mounting along with the balancing in order to keep them running for a long time. It’s not possible to get a second chance, not for tyres Oatley at least. A simple tyre mistake can lead to the long-term issue. Getting familiar with the common yet serious tyre mistakes can save you and your vehicle from permanent damage.

So what exactly are those mistakes you should avoid? Let’s find out now!

1. Failure to Recognize Tyre Pressure

You might have heard about people getting in trouble in the middle of nowhere; because, of unexpected tyre failure. Low pressure could be the primary reason behind it. Having a pressure monitoring device at a place is best you can do for a long-run of your tyres. Even if it looks okay, pay special attention to TPMS (Tyre Pressure Monitoring System) readings. That’s the only way to figure out the lifespan of the tyres and whether or not you need to change them. Before you go for tyre service, make clear that you have measured the pressure and how much air do you need to put inside your tyres Hurstville.

2. Improper Reverse Mount Wheel Handling

The trending reverse mount wheels are prone to scratched wheel surface if not handled carefully. This could lead the scratches on chrome rim to transform into rust. Rust can obviously damage your wheels and tyres to a large extent. Therefore, it’s better to take jaw protection as a precaution.

3. Using Insufficient Lubricants

Using lube during both procedures - mounting and removing is imperative. But if you apply excessive lube or wrong mixture with water on hub centric wheel spacers or any other portion near tyre/wheel, it can result in extreme slippage. You might also feel some vibrations too. Besides, incorrect lubes can completely corrode your wheels. Don’t forget to apply lube on the inner tire bead areas, seats, and balcony of the wheel drop centre.

4. Holding the Bead Using Hand-Held Bar

The tire bead rips when you slip the bars and tyre come up. The bars get broken due to harsh hand-holding. It involves a huge amount that you might have to spend on its maintenance. So it’s better to be careful with the bead and hand-held bars for making your tyres and wheels as functional as possible.

Prevention is better than remedy. Whether you have aluminum hub centric rings or anything else, don’t make these mistakes. Keep all these tyre mistakes in mind and let yourself experience the glitch-free driving.

So do the best care for your tyres!